What is Dymo LabelWriter 400 Turbo

Dymo LabelWriter 400 Turbo is a device specifically used to print labels. The device is connected to a computer with a USB cable or through a Serial port.

Most of the errors encountered by Dymo LabelWriter Turbo 400 are related to connectivity. This post lists some common errors that you may encounter while using the Dymo device and simple solutions for these problems.

Fix problem where USB-connected LabelWriter fails to print

One of the reasons for LabelWriter not printing is the labels are not properly loaded in the spool. If that is the case, then you need follow the steps given below to resolve the issue.

• Remove the power supply chord from the power outlet. Wait for 30 seconds and reconnect the power supply chord.
• Start DYMO LabelWriter
• Go to Start->Control Panel -> Printer and Faxes
• Click on File and Select Change Printer
• Select Label Writer 400 Turbo from the list and print a label.

Note: It is necessary that you update the Firmware in the Dymo LabelWriter 400 Turbo to avoid any further issues. You need to use the LabelWriter Firmware Updater utility and follow the on-screen instructions to update the LabelWriter firmware.

Fix problem where Serial port-connected LabelWriter is Not Printing

You are more likely to experience this issue if you have Port (COM & LPT) monitoring utilities or HotSync(R) Manager application installed on your computer. These programs are known to prevent communication between your computer and LabelWriter 400 Turbo. One of the ways to resolve this issue is by disabling these utilities when you print with LabelWriter. Another solution to this problem is to configure the Port settings to ensure proper communication between your system and LabelWriter.

Follow the steps given below to configure the Port settings

• Click on Start-> Control Panel -> Printer and Faxes
• Locate DYMO LabelWriter printer in the Printer folder, right-click it, and select Properties
• The settings should match as given below
  BPS Data – 115200
  Bits – 8
  Parity – None
  Stop Bits – 1
  Flow Control – Hardware
• Make the necessary changes if required and click OK

Solution for Error Message when sending Print jobs

If you are getting an error message while sending print jobs, try unplugging the device and plug it in again. The majority of the time, it is a temporary issue which gets resolved after unplugging and plugging in the device again.

How to fix the error “Cannot install this device. No driver found for this device.” when displayed at the end of the installation. (D060003)

There can be several reasons for this error such as your system is unable to load the latest Driver for the LabelWriter. To resolve this error, follow the steps below.

• Go to C:WINDOWSINF and look for NTPRINT.INF file
• Rename it to NTPRINT.OLD
• Go to C:WINDOWSServicePackFilesi386 and copy the NTPRINT.INF to C:WINDOWSINF folder
• If there is no ServicePackFiles folder, you need to install Service Pack available for your Windows OS.
• Delete INFCACHE.1
• Reboot and install Dymo LabelWriter 400 Turbo again.

Dymo LabelWriter 400 Turbo Drivers are vital to enable proper communication between your system and the printer. Therefore, it is strongly recommended you keep the Drivers up-to-date in order to prevent any errors.

To update your Dymo LabelWriter 400 Turbo Drivers automatically, try using a driver update tool.

View Driver Update Tools Here